XBees turning on a red LED at 4 foot distance. I also tried this from one floor down and it still worked perfectly.
And testing them both inside Space Rock ‘shells’.
The blog
XBees turning on a red LED at 4 foot distance. I also tried this from one floor down and it still worked perfectly.
And testing them both inside Space Rock ‘shells’.
Testing the speaker inside a (one-half) Jesmonite Space Rock.
A series of photos showing the first attempts at casting the Space Rocks in Jesmonite, along with some further 3D printed parts to hold the circuitry and electronics.
The latest version of Space Rock #4, sanded and with the circuit board and powerbank holder printed for inside. Also shown is a version of Space Rock #1 printed in sections at 280mm wide, and coated with XTC 3D as a test as this print has lots of flaws – not least because the filament snapped just before finishing printing the front section, so I had to do a patch repair. Interesting to see how smooth this sands down.
Testing a 3D print of my face using the online 3D Face Reconstruction from a Single Image tool.
Small (45mm) 3D printed Space Rocks, that glow in the dark.
Looking at ways to make the Space Rock shapes less rigid / more flexible.
A small test, mould-making from the lumpy Space Rocks created using Meshmixer, plus the resulting Jesmonite cast.
Managed to get the XBees talking to each other, following these steps. The video shows two completely unconnnected Arduino circuits. The one on the right (coordinator) sends the reading from the potentiometer to fade the light on the board on the left (receiver).
You must be logged in to post a comment.