The final four Space Rock shapes.
Category: prototyping
Audio amplifier
I have four M386 Super MINI Amplifier Boards. Just need to assemble them now…
Taking shape
The latest version of Space Rock #4, sanded and with the circuit board and powerbank holder printed for inside. Also shown is a version of Space Rock #1 printed in sections at 280mm wide, and coated with XTC 3D as a test as this print has lots of flaws – not least because the filament snapped just before finishing printing the front section, so I had to do a patch repair. Interesting to see how smooth this sands down.
Mini-Me
Testing a 3D print of my face using the online 3D Face Reconstruction from a Single Image tool.
Revised Space Rock circuit sketch
Refining the Space Rock shapes
First refined version of shape 4. The outer shell has been sanded ready to be cast (as a test). And some test prints in PLA of the inner part that holds the power bank and circuit board. The first version of this is not deep enough and the screw holes are a little too close to the edge of the print.
Glow-in-the-dark Space Rocks
Small (45mm) 3D printed Space Rocks, that glow in the dark.
Could the Space Rocks breathe?
Looking at ways to make the Space Rock shapes less rigid / more flexible.
First attempt at mould-making with silicone and casting in Jesmonite
A small test, mould-making from the lumpy Space Rocks created using Meshmixer, plus the resulting Jesmonite cast.
Baby speakers
The tiny audio speakers have arrived. I didn’t realise they would be so small. They are 2W 8 Ohm and 23mm in diameter. And also a little bit quiet.


































































You must be logged in to post a comment.